Manual End Changer

  • Low Cost
  • Compact
  • Automatic end identification
  • Smooth accurate indexing

DESCRIPTION     The manual end changer system can be a simple, compact and low-cost system for processing up to two different product arrays. It is most suitable for smaller products in medium to high production volumes.


Lewmar-front.jpg (10214 bytes)

MECS.jpg (11702 bytes)

HOW THE SYSTEM WORKS     The operator loads one side and the robot works on the other. When the operator has finished loading they either manually rotate the system or presses the “loader pushbutton” to automatically change ends and the cycle is then repeated.

PRODUCT CHANGES     Jobs are fixed into position to ensure repeatability. Fixtures are usually located on dowels to ensure they are correctly positioned when replaced.